Sump Pump Repair in Caldwell
Over the lifetime of your sump pump, you can expect to need repairs occasionally. Some repairs can be quick fixes to get your pump back up and running, while others may require a whole new sump pump installation.
Either way, it is helpful to leave the problems you experience with your pump to our professional septic company.
You can experience many problems with your sump pump over its lifespan:
- Casing damage
- Motor failure
- Switch malfunction
- Stuck float
- Discharge and inlet line clogs
- Power failure
- Check valve malfunction
Your device’s pump sits inside a hard casing, which protects it from unwanted damage. Unfortunately, if your pump experiences excessive vibration or physical wear, the casing can crack and damage the pump. A cracked casing is most noticeable when you lift the sump pump out of the basin and examine the entire housing closely.
If the water level is rising and your pump won’t turn on, there could be a number of issues. First, it’s best to check the circuit breaker to ensure that your pump actually has power.
During bad thunderstorms, power surges can cause the breaker to trip unexpectedly. If power is going to your device, the problem may lie with the float, motor, or switch.
When the water in your basin rises, the float inside your pump gets pushed upward. This naturally causes the pump’s switch to kick on, turning the pump on to remove the unwanted flood water.
As debris moves through the unit, the float may get stuck in a closed position. Sometimes, cleaning the float can remedy this issue. In other cases, the switch may have gone bad and must be replaced.
It can be frustrating when your sump pump kicks on but won’t remove any water. Standing water could be due to a clogged inlet or discharge line.
Locating and removing the debris should allow water to flow freely out of your basement. If not, the check valve may be broken. This valve is responsible for keeping water from flowing backward into the pump.